I've figured out that there are strict timings in remote's firmware when reading data from USB port (sent from the computer) and the file need to be sent without any interruption. When I was trying to write data directly to FileOutputStream (in Java) opened on settings.bin file on the remote, the file was corrupted after writing and the remote couldn't boot. I've also stumbled upon this problem on Windows during writing the reader/writer module for settings.bin. RemoteMaster (RMIR) software I've mentioned in my first reply also cannot write to the remote under Linux using USB connection. I've spent many hours trying to figure out how to overcome this problem using some file system options without success. It's in the implementation of the Mass Storage USB protocol (which is very simplified and not even near 100% complete) in the remote which makes it incompatible with Linux. It really shouldn't matter what my OS is, as long as it can save to a FAT filesystem. Is known to work or not to work with Ubuntu? It wouldn't respond to anything except as a USB drive until I used again with my backup of the original settings.bin and Windows 7 in a virtual machine. I tried to use Ubuntu Linux to access it, and the resulting settings.bin bricked the remote. If you are interested there is a thread here about recently added SimpleSet support (I'm the author of the component in RMIR which allows it to read and write settings.bin file). If you need more control there is a dedicated community Java application written by the people from which you can use to edit settings.bin file on your computer. Some of this functions can be changed from. The code works on the 6440 so it should also work on 6430.īTW if you want to know more about 9xx codes you can go to this page:īe careful and don't try entering not known codes as this can give unknown results. If it lights up once but longer it means that the operation was not accepted. Press TV button (new mode of the selected device button).Īfter this operation the LED should blink twice.Press PVR button (device button you want to remap).LED should blink twice if the code is accepted. Enter SETUP by pressing and holding WatchTV/Setup button until the LED blink twice.There is also a way to change button mode using special codes on the remote itself. It's also best to select the brand you will be assigning to the button in the simpleset creator as this will sometimes provide upgrades to the device codes and button maps. Save your modified settings.bin and upload it into remote.Īfter that you can assign TV code to PVR button.You can go back to first page of the creator by clicking the Remote Setup link in breadcrumbs on top of the page.From the list select TV mode and press Done.Select device button which you want the mode changed (for example PVR).On brand selection page click on "More Options" link below brand list.Select "Add a device" and select any of the device buttons (it doesn't matter which one you select now).Press "Start setup", select your remote model and upload settings.bin file from the remote.To use TV codes on PVR device button you first need to change device type mapping, because it won't accept a TV code otherwise. TV codes are better than other types because they usually allow to use all the keys on the remote. If you have a Samsung TV you can also use Panasonic or LG codes. I have URC-6440 (4-device model from the same series) and I'm using Samsung TV code ( 2051).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |